Electronic hanger A200 of the boxlike

　　When using the hanger , close the electricity original floodgate knife at first , make the hanger have the electricity, thus in the state of awaiting orders , through the flagging manipulation box , press the green (fall ) according to the knob, the motor has the electricity and rotates, through moderating the organization, the sprocket rotates in the down direction, pull organization , open at first, then to fall. Unlocking the button, down sports stop. Press the green button at this moment and no longer fall too. Can use the projector . After the projector is used up , it can press the red up button to keep the projector well, according to is it rotate direction is it run to set up an electric circuit , through moderating the organization , pull the sprocket to upgo motor, make the hanger upgo, unlock the button , upgo and stop, press the red button again, by continuing upgoing, until reach and go to the location position of the terminal limit. And shut the door automatically. At this moment, up end. And then press the up button invalid too. If this projector has already been used up, has no longer used temporarily, can divide and have the floodgate broken . (shut off the power) operate and is over. Notice: Must shut off the bulb first before packing up after the projector is used up , after fully dispelling the heat, shut off the projector power and can just be packed up and closed the hanger box chassis . Otherwise apt temperature is too high in causing the case, damage the projector.